• 0845 269 3351
  • info@sw3plumberchelsea.co.uk
  • Mon - Sun: 24 hrs
    • May

      5

      2014
    • 463
    • 0

    Shower Tray (fit)

    The Trap and Waste Pipes:The drainage pipework is the first consideration to be made before you begin any shower tray installation as you will need to work out how you’re going to run them and check how much height you need under the tray for this pipework. It could be that you are able to

    • May

      4

      2014
    • 532
    • 0

    Shower Types and Fit

    The shower that you choose should always be one that will use your homes plumbing system to its maximum. So make sure that you consider this before you choose. This means that if your system is gravity fed, or you have a hot water cylinder and a cold-water storage cistern up in your loft you

    • May

      3

      2014
    • 454
    • 0

    New Sink (kitchen)

    Tools and Fittings:Cross-headed screwdriver, hacksaw, adjustable spanner, water pump pliers.Taps, sink and waste fittings, sanitary silicone sealant, 15mm push fit flexi tap connectors.When you are going to replace a sink with a new unit, the space should be measured very carefully. If required, extend the nearby hot and cold water supply pipes so that you

    • May

      1

      2014
    • 453
    • 0

    Fit Valve and Rail (for mixer shower)

    Tools required: Adjustable spanner, chinagraph pencil, cable and pipe detector, drill with masonry bits, and spirit level.When fitting the rail, it should be set high enough to suit the tallest user, however not that low that the showerhead will hang any less than 25mm from the spillover level of the shower tray or bath, or

COST CALCULATOR

Use our form to estimate the initial cost of renovation or installation.

REQUEST A QUOTE
Latest Posts
Most Viewed
Text Widget

Here is a text widget settings ipsum lore tora dolor sit amet velum. Maecenas est velum, gravida Vehicula Dolor

Categories